Specialty Tools

Valve Tappet Feeler Gauge

11 Offset Steel Blades. Precision blades are offset at the proper angle for adjustment of valve tappets. Blades are approximately 1/2 inch wide by 4 inch long. 11 Offset Steel Blades. Precision blades are offset at the proper angle for adjustment of...

Bearing Race and Seal Driver Set w/Case

Makes it Easier to Insert Bearing Race.Insert bearing race quickly, straight in on FIRST TRY! Helps reduce damage to both race and axle housing. Turn driver over to drive seals.Makes it Easier to Insert Bearing Race.Insert bearing race quickly, straight...

Tie Rod Separator

18520 is used to replace worn out tie rods and to separate shock absorber links. The tine opening is 21/32 inch.18520 is used to replace worn out tie rods and to separate shock absorber links. The tine opening is 21/32 inch.

Seal Driver Kit

Quickly Drives Seals Without Damage. Sixteen adapters for seals up to 3 3/8 inch diameter. Includes special adapters for inchshielded seals.Quickly Drives Seals Without Damage. Sixteen adapters for seals up to 3 3/8 inch diameter. Includes special...

Hub Holder for Water Pump and Fan Clutch Removal on BMW

Features and Benefits: For water pump hub needed for removal of fan clutch. Used in conjunction with tool # S 10 32 x 36 Applicable: BMW engine models M10, M20, M30 with 32 mm fan clutch nut.Features and Benefits: For water pump hub needed for removal of...

Ball Joint Separator

18530 is used to replace worn out ball joints and to remove CV drive shafts on FWD vehicles. The opening is 15/16 inch.18530 is used to replace worn out ball joints and to remove CV drive shafts on FWD vehicles. The opening is 15/16 inch.

Honda/Nissan Oil Filter Wrench

Features and BenefitsOil Filter Wrench Applicable to many late model Honda, Nissan and Infiniti Models 24 mm Hex fitting on the top of the wrench cup Cast Aluminum construction 3/8" Drive The Honda/Nissan Oil Filter Wrench is applicable to: June 1997 and...

Oil Pan Plug Wrench For GM

Removes the 3 1/4 inch Drain Plug on GM Four Cylinder Cars Where the Oil Filter is in the Pan.Works where the original hex on the plug has been rounded off. Simply install wrench into recess in plug and turn counterclockwise to loosen. Reverse...

Big Range Filter Wrench (Up to 6 in )

Adjusts quickly to fit any spin-on oil filter up to 6 inch diameter. Use with 1/2 inch drive or 3/4 inch wrench. Strong polypropylene belt.Adjusts quickly to fit any spin-on oil filter up to 6 inch diameter. Use with 1/2 inch drive or 3/4 inch wrench...

Tap Socket Set-1

For Use in Restricted Areas. Ideal for use in areas where a T handle won't fit. Set of 8 sockets fits all number and fractional M.C.T.I. standard taps thru 1/2 inch. Also fits 1/8 inch NPT taps and metric taps thru 12mm manufactured to M.C.T.I. standards...

Master Fuel Injection Test Set

Disconnects the Fuel Module on 98 & Later GM Full Size Pickups, Suburban & Tahoe.Two piece design allows access to the connectors. Slide the proper size end into the connector. Rotate and slide the other half in place. Now the module can be disconnected...

Small Engine Ring Compressor. 1-1/2 in to 3 in

The Lisle spring clutch assures a proper fit on the piston and a positive locking action.