Clutch tools

Clutch Pilot Bushing Remover

Uses Hydraulic Pressure to. Remove Brass and Bronze Bushings.Screw the self-tapping tip 2-3 threads into the brass or bronze bushing. Then pump out the bushing with a grease gun. Fits brass or bronze bushings from 1/2 inch to 3/4 inch I.D. Not for use...

Ford Disconnect Clutch Line Fork Tool

Features and Benefits:For removing hydraulic clutch line from the internally mounted slave cylinder on the following Ford vehicles with manual transmissionApplicable: 1989 and newer Aerostar, Bronco II, Explorer F150, and Ranger.Features and Benefits:For...

Clutch Alignment Tools-1

Faster, Easier Replacement of Clutches.Align clutch plates and pilot bearings accurately. 55500 shaft and bushings provide an accurate fit for eight pilot bearing sizes. Tapered cone handles the rest. 61750 has a shaft, ten pilot bushings and two plate...

Clutch Alignment Tools

Features and Benefits: A tapered cone to fit all others is provided Clam shell package Built durable, made to last For faster, easier replacement or repair of metric clutches, this is the answer.  This tool consists of the shaft, ten pilot...

Clutch Coupling Remover For Ford

Disconnects Ford Hydraulic Clutch Lines. Easily disengages the hydraulic clutch line from the clutch slave cylinder on some Ford manual transmissions. Tool prongs fit around clutch line above nylon sleeve. For 1989 and newer Mercury Cougars and...

A/C Compressor Clutch Installer/Remover Kit

Replaces clutches found on FS6, C171, 6P & 148 compressors GM R4 & A6, HR-6, DA-6 & V5 A/C compressors, Sanden compressors SD505, 507, 510, 575, 708 & 709 2 & 3 hole puller plate fits most clutches, mechanical force does the pulling Blow molded case for...

Compressor Turner Tool

Features and Benefits: Threads into the clutch hub Fits most hex-less clutch hubs Uses standard 19mm (3/4) wrench Allows you to check for internal damage Helps free a compressor that has seized due to sticky protective coatings Compressor...