• 11,000lb capacity asymmetric / symmetric two post overhead vehicle lift • Rigid single piece column construction provides strength and durability • Bi-Symmetric arm design offers the best of both worlds allowing both asymmetric and symmetric lifting by using a three stage short arm that can be set for either asymmetric or symmetric lifting • Reduced overall width while maintaining drive thru with front mounted power unit • Direct pull style cylinder • Pull style cylinders become stronger as the vehicle raises vs a push style cylinder that is at its weakest point when the vehicle is fully raised • Rubber door guards limit damage to car doors when entering and exiting a vehicle • Low profile arms with a pad height of 4” allows lifting of the even the lowest sport cars • Spin up lifting pads allow for 2 1/8” of adjustment • This often allows the technician to contact the lifting point prior to lifting for positive lifting point engagement • Truck adapters allow raising of the lifting pad to lift around running boards or to access recessed lifting points • Also can be used on some vehicles to realize “extra” lift height • Four each 2” and 4” adapters included • Padded overhead shut off protects vehicle by cutting power to the motor when contacted by the lifted vehicle • Single point lock release provides single side controls reducing down cycle operation time when compared to dual point lock release • Internal hose routing eliminates damage that might occur if hoses were externally routed and provides for a clean professional look • Automatic arm restraints integrated into the carriage design to eliminate potential contact when exiting vehicle • Durable powder coat finish • Optional: Spin up style cradle adapters for positive frame engagement
Special order item only, please call customer service.