Urrea

4-3/4 Inch Center And Prick Punches 44-1/4

50° center punches are used to mark pieces in manufacturing or assembly. 90° prick punches are used to center the bore point and

4-3/4 Inch Flat Tip Electronics Pliers 28580

Self-opening, spring-loaded handles. Pointed and sharp nose for precision cutting of circuit board edges and burrs.  Exceed ASME B107.500 standard Tool Length: 4-3/4 inches Jaw Width:...

4-3/4 Inch Long Nose, Non Cutting Heavy-duty Electrician Pliers 282G

Ergonomic design provides greater contact area, minimizing the effort required to use them while decreasing the fatigue felt from continuous use. Electrician or linemans pliers offer 46% greater...

4-3/4 Inch Long Nose, Non Cutting With Spring Heavy-duty Electrician Pliers 282G

Ergonomic design provides greater contact area, minimizing the effort required to use them while decreasing the fatigue felt from continuous use. Electrician or linemans pliers offer 46% greater...

4-3/4 Inch Straight Drift Pin 47-1/4X3/32

Drift pins are used to install or remove guide bushings, pins, and center guides. Their length is important and it depends on the job. Straight pins can also be used to align holes when assembling...

4-3/8 Inch Straight Drift Pin 47-1/4X1/16

Drift pins are used to install or remove guide bushings, pins, and center guides. Their length is important and it depends on the job. Straight pins can also be used to align holes when assembling...

4-40 IN/LB 1/4 IN DR PREADJUSTED TORQUE SCREWDRIVER 6013

4-40 IN/LB 1/4 IN DR PREADJUSTED TORQUE SCREWDRIVER 60134-40 IN/LB 1/4 IN DR PREADJUSTED TORQUE SCREWDRIVER 6013

4-5/16 Inch Diagonal Cutting Heavy-duty Electronics Pliers 28140P

They all have high-endurance springs. All are electro static dissipative. With cushioned & ergonomic handles. Exceed ASME B107.500 standard. Tool Length: 4-5/16 inches Jaw Width: 1/2"...

4-5/8 Inch Cape Chisels 72-1/4

Tip wider than body. Edge opposite to tip designed to endure hits. Exceed ASME B107.410 standard.

4-5/8 Inch Center And Prick Punches 41-5/16

50° center punches are used to mark pieces in manufacturing or assembly. 90° prick punches are used to center the bore point and

4-5/8 Inch Short Tapered Drift Punch 50-1/4

Drift pins are used to install or remove guide bushings, pins, and center guides. Their length is important and it depends on the job. Straight pins can also be used to align holes when assembling...

4-7/8 Inch Center And Prick Punches 41-3/8

50° center punches are used to mark pieces in manufacturing or assembly. 90° prick punches are used to center the bore point and