Specialty Tools

68150 GO-NO-GO FEELER GAUGE

22 Steel Blades. Precision stepped blades have a .002" step for accurate settings. Blades from .004" to .027" (.102 - .686mm) are approximately 1/2" wide by 3 1/4" long.

68200 - OBSOLETE AT FACTORY BRASS FEELER GAUGE

6 Brass Blades. Precision blades are non-magnetic, for use in adjusting reluctor air gap on electronic ignition systems. Blades are approximately 1/2" wide by 3" long.

31320 - OBSOLETE AT FACTORY 3 JAW REVERSIBLE 2 TON PULLER

3 Jaw, 2 Ton Puller 3 Jaw, 2 Ton Puller. 3-1/2" Reach and 4" Spread.

31330 - OBSOLETE AT FACTORY 2 OR 3 JAW REV. & ADJ. 5 TON PULLER

2 or 4 Jaw Reversible & Adjustable 5 Ton Puller 2 or 3 Jaw Reversible & Adjustable 5 Ton Puller. 5-1/2" Reach and 7" Spread.

38850 - OBSOLETE AT FACTORY PULLEY PULLER / INSTALLER

Removes and installs pressed on power steering, alternator and air pump pulleys. Makes removing pressed on pulleys an easy job. This puller will remove and install pulleys on most GM, Ford and Chrysler vehicles. Special adapters are included for GM 3.1...

39000 NO SLIP PULLEY PULLER

Removes and installs pressed on power steering, alternator and air pump pulleys without slipping. The unique puller body completely houses the pulley hub to prevent slipping on even the tightest pulleys. Fits most domestic models including GM 3.1 and...

41670 - OBSOLETE AT FACTORY 2 JAW ADJUSTABLE 2 TON PULLER

2 Jaw Adjustable 2 Ton Puller 2 Jaw Adjustable 2 Ton Puller. 3-1/2" Reach and 4" Spread.

41690 - OBSOLETE AT FACTORY 2 JAW REV. & ADJ. 5 TON PULLER

2 Jaw Reversible & Adjustable 5 Ton Puller 2 Jaw Reversible & Adjustable 5 Ton Puller. 5-1/2" Reach and 6" Spread.  

41700 - OBSOLETE AT FACTORY 2 JAW ADJUSTABLE 5 TON PULLER

2 Jaw Adjustable 5 Ton Puller 2 Jaw Adjustable 5 Ton Puller. 5-1/2" Reach and 6" Spread.

41780 - OBSOLETE AT FACTORY TIMING GEAR PULLER

Pulls Timing Gears as Well as Other Gears with Threaded Holes. The 5" wide bar design allows threaded bolts to work with a wide range of threaded hole patterns on gears. The bolt slots are .410" wide.

45000 STEERING WHEEL PULLER

Universal Puller for Most Makes and Models. Screw pad protects end of steering shaft. Heavy duty for long wear.

45300 HARMONIC BALANCER PULLER FOR GM

For GM 3300 And 3800 V6 Cylinder Engines. The 45300 is equipped with the special bolts and adapters to pull the harmonic balancer cleanly without damage to the crank sensor. Order the 45350 Retrofit Kit to use with your Lisle 45500 Harmonic Balancer...