Specialty Tools

20700 COIL-ON-PLUG SPARK TESTER

Provides an Easy Way to Check Ignition Systems with Coil-On Plugs. Applications Include Ford, Chrysler, Mitsubishi, Nissan and More. It is the quickest way to test for no-start conditions. An inductive test cannot be performed, because there are no plug...

20750 REMOTE STARTER

Tough, Smooth-working Reliable Switch. Features heavy gauge, rubber-covered coper wire. Depress button to jog or start the engine.

22850 HOSE PINCHERS

Sold Two Per Set. A quick, easy way to pinch off vacuum lines, fuel lines, etc. without damaging the line.

36880 DUAL OVERHEAD CAM (DOHC) LOCK TOOL

Locks Camshaft Sprockets in Place During Belt / Chain Replacement. This versatile tool easily locks and holds both camshaft sprockets firmly in place. Unique design uses knurled pins to hold against the inside of the cam sprockets. The two parallel bars...

46500 - OBSOLETE AT FACTORY CARBURETOR PIN TOOL

Also for "E" clips and other small parts. For fast, sure removal and installation of carburetor linkage pins.  

48300 PUSH ROD REMOVER

Redesigned for Newer 3.5L and 3.6L GM Engines. Also Works on GM V6 2.8L, 3.1L and 3.4L.   Quickly removes push rods so you can replace the intake gasket.  No need to loosen and retighten the rocker arm.   The tool pivots the...

48700 THROTTLE PEDAL DEPRESSOR

Holds Throttle at a Constant RPM. Engage the nylon hook under the steering wheel. Then extend the depressor rod to the accelerator pedal. Use the adjustment screw to fine-tune the RPM level. Tool is 40" in overall length.

50850 IGNITION SPARK TESTER

Quickly Checks Spark at Plug Wire. A handy tool to check ignition spark without removing the spark plug. The tool is specially calibrated to measure ignition voltage. Works on both standard and electronic ignition systems. Easy to use. Simply adjust...

51250 SPARK PLUG WIRE PULLER

Removes Spark Plug Wire Boots from Plugs. A simple, yet effective tool for disengaging spark plug boots. Tool performs well in difficult areas such as recessed and obstructed plugs. Square shaft prevents slipping. Thick plastic handle prevents electric...

51410 OFFSET SPARK PLUG BOOT REMOVAL PLIERS

Used to Remove Stubborn Spark Plug Wires on GM 3.1L, 3.4L, 3.8L and Other Engines.  The 5/8" opening of the pliers properly fits spark plug wire boots to prevent damage to spark plug wires. Tool is 7" long with offset tip to fit in tight spots.

51420 DOUBLE OFFSET SPARK PLUG BOOT REMOVAL PLIERS

Used to Remove Stubborn Spark Plug Wires. The 5/8" opening of the pliers properly fits spark plug wire boots to help prevent damage. Offset design works great on boots with heat sleeves found on some GM engines. Easyto-use in tight spaces such as rear...

51500- OBSOLETE AT FACTORY SPARK PLUG WIRE PULLER

Nylon Stops the Shocks and Beats the Heat and Burns. Helps you pull spark plug wires quickly, easily and without damage to the wire or rubber boots. ÿ