Specialty Tools

Inner Tie Rod Tool with 1-1/2 in Size Included

Includes an Additional 1 1/2 inch Crows Foot for Chevrolet Colorado and GMC Canyon. Works on tie rods with inaccessible flats. Many inner tie rod end sockets do not have a complex hex on the full length of the socket. The rounded socket ends prevent...

Inline Spark Tester

Gives a Visual Check of the Ignition System. Quickly diagnose problems with all ignition systems. Connect the tool between the spark plug and the plug wire. The tool is double-ended to offer a straight boot and a 90 boot on one tool. With the engine...

Torque Angle Meter LIS28100

For All Torque-to-Yield Fastener Applications. Commonly used for tightening head bolts and other bolts where a torque angle is required. Use with 1/2 inch drive.For All Torque-to-Yield Fastener Applications.

Tamper Resistant Torx Bit Set

Seven 1/4 inch Hex Insert Bits with 1/4 inch Drive Bit Holder. T-10 Through T40.Fits tamper-resistant Torx fasteners found on radio mountings, exterior mirrors, carburetors and other applications.Seven 1/4 inch Hex Insert Bits with 1/4 inch Drive Bit...

Spark Plug Wire Tester

Quickly Locate Faulty Plug Wires. No Shock Hazard. Now you can check spark plug wires without piercing the wires. Light flashes indicating sound wire. Quickly Locate Faulty Plug Wires. No Shock Hazard. Now you can check spark plug wires without piercing...

Valve Tappet Feeler Gauge

11 Offset Steel Blades. Precision blades are offset at the proper angle for adjustment of valve tappets. Blades are approximately 1/2 inch wide by 4 inch long. 11 Offset Steel Blades. Precision blades are offset at the proper angle for adjustment of...

Bearing Race and Seal Driver Set w/Case

Makes it Easier to Insert Bearing Race.Insert bearing race quickly, straight in on FIRST TRY! Helps reduce damage to both race and axle housing. Turn driver over to drive seals.Makes it Easier to Insert Bearing Race.Insert bearing race quickly, straight...

Tie Rod Separator

18520 is used to replace worn out tie rods and to separate shock absorber links. The tine opening is 21/32 inch.18520 is used to replace worn out tie rods and to separate shock absorber links. The tine opening is 21/32 inch.

Seal Driver Kit

Quickly Drives Seals Without Damage. Sixteen adapters for seals up to 3 3/8 inch diameter. Includes special adapters for inchshielded seals.Quickly Drives Seals Without Damage. Sixteen adapters for seals up to 3 3/8 inch diameter. Includes special...

Hub Holder for Water Pump and Fan Clutch Removal on BMW

Features and Benefits: For water pump hub needed for removal of fan clutch. Used in conjunction with tool # S 10 32 x 36 Applicable: BMW engine models M10, M20, M30 with 32 mm fan clutch nut.Features and Benefits: For water pump hub needed for removal of...

Ball Joint Separator

18530 is used to replace worn out ball joints and to remove CV drive shafts on FWD vehicles. The opening is 15/16 inch.18530 is used to replace worn out ball joints and to remove CV drive shafts on FWD vehicles. The opening is 15/16 inch.

Honda/Nissan Oil Filter Wrench

Features and BenefitsOil Filter Wrench Applicable to many late model Honda, Nissan and Infiniti Models 24 mm Hex fitting on the top of the wrench cup Cast Aluminum construction 3/8" Drive The Honda/Nissan Oil Filter Wrench is applicable to: June 1997 and...