Lisle

Air Conditioning / Fuel Line Disconnect Tool Set

Easily disconnects air conditioning lines and quick connect fuel lines Set of six tools which disconnect the spring lock couplings on Ford and Chrysler air conditioning line Also works on fuel line...

Aluminum Vise Jaw Pads

Ideal for Holding Round and Hex Parts Securely. V-shaped aluminum surface holds and helps protect round or hex parts. Specially designed ledge supports flat parts while clamping. Strong nitrile...

Angled Disconnect Tool Set

Disconnects Air Conditioning and Quick Connect Fuel Lines. Disconnects spring lock couplings on Ford and Chrysler AC lines. Works on fuel lines and other quick disconnect couplings on domestic and...

Antenna Nut Socket Set

For Removing or Replacing Antennas Four double-ended sockets fit eight common domestic & import antenna nuts. The smaller three sockets are 7/8 inch hex & the larger socket is 1 1/4 inch hex...

Arm Glove

Total Hand and Arm Burn Protection.The heat resistant Kevlar® material protects hands and arms from hot surfaces. This enables work on hot engines and exhaust systems without waiting. Works on...

Audio Stethoscope

Detects Noise From Vacuum Leaks, Exhaust Leaks, Wind Noise & Air Leaks.Detects air induced sounds not detected by conventional stethoscopes. Place funnel over suspected air leak. Detects Noise...

Ball Joint Separator

18530 is used to replace worn out ball joints and to remove CV drive shafts on FWD vehicles. The opening is 15/16 inch.18530 is used to replace worn out ball joints and to remove CV drive shafts on...

Basic Fuel Injection Test Set

This set checks fuel pressure on most domestic (except GM TBI) and Japanese Fuel Injection and Throttle Body Injection Systems. Tests the following: Bosch AFC, MPC, Digijet/Digifant - except C.I.S.;...

Battery Brush

Cleans dirt and corrosion from battery terminals and cable clamps. The external brush cleans cable clamps and internal brush cleans terminal posts. Case is made of high impact plastic that will not...

Battery Carrier

Lift and Carry Batteries Safely.Sturdy steel jaws securely hold batteries. Spring-action handle turns lifting power into battery gripping pressure. Form-fitting handle provides a solid gripping...

Battery Terminal and Wiper Arm Puller

A dual-purpose puller. Easily removes stuck battery terminals. Tighten knurled cone to force jaws under the cable clamp. Turn center screw to lift clamp off terminal. Also removes bolted on...

Bearing Locknut Tool LIS28010

Removes and installs the bearing lock nut on the rear axle of some Chevrolet and GMC vehicles Fits the six slot lock nut Use with 3/4" dive Found on some Chevrolet and GMC vehicles For 9-3/4" DANA...